DINE drill bit clamp BT head

Vendor: DINE Eng

– There are a full range of taper shanks to suit each processing machine: MT, BT, NT, R8, SK, CAT, JC, etc.
- The size of the cone type you can refer to here.
– All parts are heat treated, polished to high gloss.
– The drill chuck and the clamp shank have been installed together, so the error due to the installation of these two parts is minimal.
– The drill bit holder is difficult to fall out.
- Absolutely safe to use.
– The accuracy of the drill clamp is: 0.05mm.
– Hardness reaches over 50 HRC, good wear resistance.

– Vertex drill chuck: INT-8-MT-2, INT-8-JC-20, INT-8-BT30, INT-8-BT40, INT-8-NT30, INT-8-NT40, INT- 8-SK30, INT-8-SK40, INT-13-R8, INT-13-MT2, INT-13-MT3, INT-13-MT4, INT-13-JC-20, INT-13-JC-25, INT-13-JC-32, INT-13-NT30, INT-13-NT40, INT-13-NT50, INT-13-BT30, INT-13-BT40, INT-13-BT50, INT-13-SK30, INT-13-SK40, INT-13-SK50, INT-16-R8, INT-16-MT3, INT-16-MT4, INT-16-JC-20, INT-16-JC-25, INT-16- JC-32, INT-16-NT40, INT-16-NT50, INT-16-BT40, INT-16-BT50, INT-16-SK40, INT-16-SK50:.